Publicité
Les langues disponibles
Les langues disponibles
•
Accumulation of dust at the condenser increases energy consumption. For this
reason carefully clean the condenser at the back of the appliance once a year with a
soft brush or a vacuum cleaner."
•
After everything is dry place appliance back into service.
7. TROUBLESHOOTING
Caution! Before troubleshooting, disconnect the power supply. Only a qualified
electrician of competent person must do the troubleshooting that is not in this
manual.
Important! There are some sounds during normal use (compressor, refrigerant
circulation).
Problem
Appliance does not
Temperature regulation knob is
work
set at number "0".
Mains plug is not plugged in or
is loose
Fuse has blown or is defective
Socket is defective
The food is too
Temperature is not properly
warm.
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Appliance cools
Temperature is set too cold.
too much
Unusual noises
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data
here, refer to the rating plate.
Possible cause
15
15
Solution
Set the knob at other number
to switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the installation
location section.
Turn the temperature
regulation knob to a warmer
setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
EN
Publicité
