Allmatic XTILUS Mode D'emploi page 20

8. CONNECTIONS AND CABLE SECTIONS
230V
4 x 0,75 mm
4 x 0,75 mm
3 x 1,5 mm
Line 230V
9. RELEASE
To move the gate manually it is necessary to release the gearmotor inserting the special key, turning it for 90° and lift up the lever (Fig. 13, 14).
In order to carry out the manual operation of the gate leaf the followings must be checked:
- That the gate is endowed with appropriate handles;
- That these appropriate handles are placed so to avoid safety risks for the gearmotor;
- That the physical effort necessary to move the gate leaf should not be higher than 225 N, for doors/gates for private dwellings, and, 390N for doors/
gates for commercial and industrial sites ( values indicated in 5.3.5 of the EN 12453 norm).
Fig. 13 Lock motor
20 - English - Translated from the original language
24V
Control unit
230V: 4 x 1,5 mm
2
24V: 2 x 1,5 mm
2
RX photocell
2
2
2
Fig. 14 Unlock motor
230V: 4 x 1,5 mm
24V: 2 x 1,5 mm
2 x 0,75 mm
2
TX photocell
2 x 0,75 mm
2
ENG
2
2
MOTOR CABLES [230V] TABLE
Black Phase 1
Brown Phase 2
Grey or light blue Common
Yellow/Green Ground
6-1624846 - rev. 19 - 11/05/2023