Allmatic XTILUS Mode D'emploi page 17

7.1 FIXING OF THE REAR PLATE TO THE COLUMN
Fix the rear plate to the column (Fig. 5, 6) in accordance to the desired coordinates. In case an iron pillar is available, screw directly onto the column the
plate with 3 screws M8. In case you need to fix the bracket onto a concrete pillar, use the fixing plate to be fastened with 3 Fischer screws of Ø 8 mm.
When the backing plate is fixed, anchor the rear part of the piston to the plate and fasten it firmly (Fig. 6).
ATTENTION! when establishing the height off the ground at which to fasten the plate to the pillar, keep in mind that the plate for anchoring the piston
to the gate must be fastened 50 mm below that on the post to obtain horizontal levelling (Fig. 9).
6-1624846 - rev. 19 - 11/05/2023
134,25
Motor
13,75
92
Ø 10,5
62
Pin
Seeger
ENG
Fig. 5
Plate
Fig. 6
English - Translated from the original language - 17