Allmatic XTILUS Mode D'emploi page 19

7.3 ADJUSTMENT OF MECHANICAL LIMIT SWITCHES
XTILUS is supplied with a mechanical limit switch for the opening (Fig. 10, 11), but it is also possible to install the mechanical limit switch for the closing
(optional), to stop opening or closing in case the gate is without ground stops.
To adjust, loosen the screw located on the limit switch and move it to the desired position. Tighten the screw on the limit switch (Fig. 12).
WARNING!
FOR OPTIMUM XTILUS OPERATION IT IS RECOMMENDED TO USE ALL THE LENGTH OF THE STEM STROKE FOR EVERY MOVEMENT. IF YOU
DO NOT USE ALL THE AVAILABLE STEM STROKE, USE THE STEM STROKE AS MOST POSSIBLE TOWARDS THE POINT OF THE MOTOR, AND
NOT TOWARDS THE REAR.
7.4 FINAL CHECK OF THE INSTALLATION
Before to proceed with the electrical cabling of the motor, check the correct movement of the gate:
1. Unlock the motor and move manually the wing of the gate (see related paragraph)
2. If the wing moves easily, the installation is correct. Otherwise lubricate the hinges, the hole in the front plate and the towing of the gate. Check the
correct installation of the motor.
6-1624846 - rev. 19 - 11/05/2023
Fig. 11
ENG
Fig. 10
Fig. 12
English - Translated from the original language - 19