Allmatic XTILUS Mode D'emploi page 18

7.2 FIXING OF THE FRONT PLATE TO THE GATE
For the fixing of the front plate to the leaf, follow this procedure:
1. Fit the anchor plate onto the piston. Insert the washer, tighten the bolt firmly (Fig. 8).
2. Close the gate.
3. Move the piston with the plate already fitted towards the gate.
4. Move the stem to the limit stop, then move it back by approximately 1 cm and mark the position of the plate.
5. Realize the same operation in opening.
6. If positions correspond, fix the plate on the gate; otherwise revise A and B coordinates (TABLE 1).
N.B.: during the installation, try several times to open and to close the gate, controlling that the gearmotor does not touch the moving gate
18 - English - Translated from the original language
106
TIGHTEN
FIRMLY
ATTENZIONE!
utilizzare una livella per il
posizionamento delle piastre
ATTENTION! Lubricate the hole
of the front plate and the towing
of the motor with silicone grease
before the fixing.
Fig. 8
ENG
92
62
92 Fig. 7
Fig. 9
6-1624846 - rev. 19 - 11/05/2023