Hoshizaki FM-481AGE-HC Notice D'installation page 3

ENGLISH
4) Remove the package of accessories, and check
the contents:
a) Mounting Bracket
b) Inlet Hose
c) Outlet Hose
d) Power Supply Cord
5) Remove the protective plastic film from the panels.
If the icemaker is exposed to the sun or to heat,
remove the film after the icemaker cools.
2. LOCATION
IMPORTANT
1. This icemaker is not intended for outdoor
use. Normal operating ambient temperature
should be within 5°C to 40°C. Normal
operating water temperature should be within
5°C to 35°C. Operation of the icemaker, for
extended periods, outside of these normal
temperature ranges may affect production
capacity.
2. The icemaker should not be located next to
ovens, grills or other high heat producing
equipment.
3. The location should provide a firm and level
foundation for the equipment.
4. Allow 15 cm clearance at rear and sides
f o r p r o p e r a i r c i r c u l a t i o n a n d e a s e o f
maintenance and/or service should they be
required. Allow 60 cm clearance on top to
allow for removal of the Auger.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. Do not place anything on top of the icemaker
or in front of the Louver.
7. Avoid prolonged exposure of the appliance
to direct sunlight.
8. T h i s a p p l i a n c e c o n t a i n s f l a m m a b l e
refrigerant in its cooling unit; maintenance
and recharging must therefore only be
carried out by authorized technicians.
3. INSTALLATION
WARNING
Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of
obstruction.
All manuals and user guides at all-guides.com
* Incorrect installation can cause harm to people,
2
1
1 1) F u l l y s c r e w i n t h e f o u r l e g s p r o v i d e d ( b i n
1
2) P o s i t i o n t h e S t o r a g e B i n i n t h e s e l e c t e d
3) Place the icemaker on top of the Storage Bin by
4) Secure the icemaker to the Storage Bin, by using
5) Seal the seam between the icemaker and the
6) Refit the Side Panels in their correct position.
7) Adjust the four legs on the bottom (adjustable
2
animals or things, for which the manufacturer
cannot be held responsible.
accessory) into the Storage Bin underside. See
Fig. 3.
Bottom Plate
Adjustable Legs
permanent site.
holding the bottom.
the two mounting brackets and two bolts provided.
See Fig. 4.
Bolt
Mounting
Bracket
Storage Bin with food grade sealant.
from 0 to 25.4 mm) to have the icemaker perfectly
horizontal. Use the spirit level. See Fig. 5.
Adjust legs
Fig. 3
Icemaker
Bin
Fig. 4
Fig. 5