Publicité
Les langues disponibles
Les langues disponibles
Always iron these fabrics at low temperatures. The plate may cool down to the point where no more steam comes out,
but
rather drops of boiling water that can leave marks or stains. In these cases, the Anti-drip system automatically activates
to prevent vaporization, so that you can iron the most delicate fabrics without risk of spoiling or staining them.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx. eight minutes in the upright position or unused
for approx. Thirty seconds in the horizontal position. The light comes on to indicate that shut off has tripped. As soon as
you move the iron, the device turns off and the iron starts working again.
G E N E R A L
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the
expanding plastics. This is quite normal and it stops after a short time. We also recommend passing the iron over an
ordinary
cloth before using it for the first time.
PREPARATIONS
Soft the laundry to be ironed according to the international symbols on the garment label, or if this is missing, according
to the type of fabric.
GARMENT
LABEL
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down) and eliminates the risk of
scorching the fabric.
STEAM IRONING
Filling the reservoir
- Check that the plug is disconnected from the socket.
- Move the steam selector (3) to "0"
- Open the lid (2).
- Raise the tip of the iron to help the water enter the opening without overflowing.
- Slowly pour the water into the reservoir using the special measure (15) and taking care not to go over the maximum
level (about 300ml) indicated by "MAX" on the reservoir
- Close the lid (2).
Selecting the temperature.
- Put the iron in a vertical position.
- Put the plug in the socket.
- Adjust the thermostat knob (11) according to the international symbol on the garment label
temperature
control light (9) indicates that the iron is heating up. Wait until the plate temperature control light goes off before ironing.
Warning:
during ironing, the plate temperature control light (9) comes on at intervals, indicating that the selected
temperature is maintained. If you lower the thermostat temperature after ironing at a high temperature, do not start
All manuals and user guides at all-guides.com
(Only ES173_01/ES173_02)
I N S T R U C T I O N S
FABRIC
TYPE
synthetic
silk - wool
Cotton - linen
Fabric not to be ironed
[Fig. 1]
.
THERMOSTAT
REGULATION
·
low temperature
··
medium temperature
···
high temperature
[Fig. 2]
.
[Fig. 3]
. The plate
20
Publicité
