Publicité
Card Features
Card PhotoShot
You can record still images to a Memory Card.
Warning
• Memory Card will not work when DV
Interface Cable (i.LINK) is connected.
3
PHOTOSHOT
2
JOG KEY
1
POWER
M-CARD
Lock
2
MENU
Image Resolution and Capacity
(supplied 8MB Memory Card)
REC
Image
Mode
Resolution
SUPER
1600 x 1200
Approx. 14 images
FINE
FINE
1280 x 960
Approx. 20 images
NORMAL
640 x 480
Approx. 70 images
• The number of images given for each
mode applies when all images are taken
in same mode.
• You can change recording modes at any
time before capturing an image.
• The number of images that can be
captured may differ depending on the
subject. After capturing an image, the
number may not decrease, or it may
decrease by two. This is normal.
Note
• 1600 x 1200 PhotoShot image is
interpolated from 1280 x 960 image.
• Some artifacting, softened edges or
picture noise may occur in Super
Fine(1600 x 1200) Mode.
48
DV702-K.p 48-51.p65
Before you begin
• Connect the Palmcorder to a power
source. (pp. 14, 15)
• Set POWER to OFF before inserting a
Memory Card. (p. 13)
1
Slide the M-CARD Lock Switch to
unlock, then set POWER to M-CARD.
• The POWER lamp lights red.
• Be sure POWER is fully turned to
M-CARD position.
• "PLAY: PUSH PLAY KEY" is
displayed for 10 seconds. (p. 50)
2
Press MENU to display CARD
SETTING menu, then press JOG KEY
to select
FINE
• Press MENU to exit this menu.
3
Capacity
Press PHOTOSHOT to record an
image.
• The PhotoShot image is recorded to
the Memory Card.
• When SHUTTER is set to ON (Menu
OSD: p. 101), still pictures are
recorded with a visual shutter effect
and click sound. If set to OFF, the still
image will be displayed only.
Warning
• While "PROCESSING" is displayed, DO
NOT turn off the Palmcorder or unplug
the AC Adaptor (supplied) because this
will cause irreversible damage to the
memory.
• When recording DV Tape playback output
to the Memory Card, only NORMAL mode
is available. (p. 49)
48
NORMAL
,
FINE
or
SUPER
.
02/06/06, 13:57
Publicité
