Trix H0 BR 96 Manuel D'instructions page 11

22012, 22016: Operating Information
• The headlights go off in a signal block.
Notes on operation with direct current
• Travel function: Forwards – Stop – Reverse.
• Headlights change over with the direction of travelde-
pends on the amount of voltage present in the track.
• A filtered direct voltage is required for operation.Ope-
rating systems with pulse duration control are therefore
unsuitable.
• Minimum voltage: 7 – 8 Volt =.
Notes on the DCC multi-train system
• Set address ex works: 03.
• Driving operation: Forwards – Stop – Reverse with load
regulation.
• Speed levels: 14 speed levels preset in DCC operation;
28 or 128 speed levels are detected and set automati-
cally.
• Controllable Functions:
– f0: Direction-dependent Headlights
– f2: Sound Effects of Steam Locomotive in Operation
- f3: Sound effects of locomotive whistle 1
– f4: Low Speed Switching Range (only ABV)
– f6: Sound Effect: Coal Being Shoveled
– f7: Sound Effectsof locomotive whistle 2
All manuals and user guides at all-guides.com
– f8: Sound Effect: air pump
– f9: Sound Effect: injector
– f10: Sound Effect: Blowing Off Steam
– f11: Sound Effect: Rocker Grate
• Changes in the registers are only effective for the most
• The installed locomotive electronics offer a wide range
• We recommend that you always change just one setting
• CV 8 is an important CV. Writing the value „8" will result
part in DCC operation. For that reason you should
leave the factory settings in conventional DC operati-
on. Malfunctions resulting from changes to the factory
settings of the locomotive electronics are caused by the
operator and do not give grounds for complaint under
our guarantee or warranty obligations.
of adjustment options according to the NMRA/DCC
standard. A series of parameters are stored to this end
in what are known as CVs (abbreviation for Configura-
tion Variable). Please refer to the operating instructions
for your system for the procedure for changing these
setting values. This operating system must comply
with NMRA/ DCC standards if a perfect programming
function is to be guaranteed. The use of an unsuitable
operating system does not give grounds for complaint
under our guarantee or warranty obligations.
value and see what effect this has.
in the complete component being reset to the factory
settings that applied at the time of delivery!
11