Cable Guides And Over Rim Cable Guide Assembly Instructions - Fluval SHAKER Mode D'emploi

Ring Nuts
(R)
Intake
Strainer (S)

CABLE GUIDES AND OVER RIM CABLE GUIDE ASSEMBLY INSTRUCTIONS

The power cables of the heater and the LED strip light will be routed out through the back of the aquarium using an over rim
cable guide which can be placed on the right or on the left.
1. Determine if the cables should come out from the left or from the right. (TIP: Heaters are most effective when positioned
near the filter output stem).
2. Place the cable guides where most appropriate, by sliding them in the
lower runner of both rails (Pict. 8).
3. Clean and dry the area where the over rim cable guide will be positioned.
4. Stick the double-sided tape in the provided location of the over rim cable
guide (Pict. 9).
5. Peel off the cover paper from the tape.
6. Apply the over rim cable guide inside the tank after aligning it with the
top edge of the glass (as shown in Pict. 8) by gently pressing it to the
glass. To ensure optimal adhesion wait 24 hours before filling the tank
with water.
ASSEMBLE THE TOP WOODEN FRAME (SEE SEPARATE INSTRUCTION MANUAL WHICH IS FOUND IN THE CABINET BOX).
8
Output
Nozzles (N)
Output
Stem (B)