EINHELL VENTURRO 36/240 Mode D'emploi page 14

4 green bars + 1 red bar = highest air velocity in
BOOST mode.
Use the equipment only with the air velocity
needed for the job.
6.3.1 SPEED mode
•
You can change the air velocity in 4 steps by
pressing the SPEED button (4).
•
If you press the SPEED button (4) again
when the highest air velocity is active, the
equipment will return to the lowest level.
6.3.2 BOOST mode
•
If you need a higher air velocity, press the
BOOST button (5). The maximum air velocity
will then be available. All the bars will appear
in the display (3).
•
Press the BOOST button again to return to
SPEED mode.
Important: To minimize noise and
maximize battery operating time, do not
work in BOOST mode any longer than
necessary.
6.4 Mode of operation
Caution! Search the surface for concealed
objects (e.g. small animals or hard foreign bodies)
before starting to use the equipment.
6.4.1 Blowing foliage (Fig. 18)
Caution!
If you point the air fl ow towards other people,
animals or objects (e.g. windows), this could
cause injuries and damage.
•
Point the air flow away from yourself.
•
Never point the air flow towards other people,
animals or objects.
•
Do not blow away any hard objects such as
stones or twigs.
•
Turn the selector lever (24) into the position
shown. You can do this regardless of whether
the tool is running or not.
•
Channel the air stream forward and walk
slowly to blow foliage or garden refuse into a
pile or to clear out hard-to-reach places.
Danger!
Never gather (blow) hot, combustible or explosive
materials into piles.
6.4.2 Sucking up foliage (Fig. 1/ 18)
Caution!
•
Only use the leaf blower vac in vacuum
mode if the collection bag is undamaged and
properly fitted.
Anl_VENTURRO_36-240_SPK7_USA.indb 14 Anl_VENTURRO_36-240_SPK7_USA.indb 14
EN
•
Do not pick up too many leaves in one go as
this could clog the tube and the shredder.
•
To clear any blockages, follow the steps
described in the section "Clearing blockages".
•
Do not pick up hard or damp materials.
•
Turn the selector lever (24) to position "B". You
can do this regardless of whether the tool is
running or not.
•
Always position the suction tube on the
ground and adjust the length of the shoulder
strap to your requirements (see section 6.1).
The castors (15) at the bottom end of the
suction tube will help you to maneuver the
suction tube on the ground.
6.5 Emptying the collection bag (Fig. 1)
Empty the collection bag (18) in good time. With
a nearly full bag, the suction power drops notably.
Organic waste should be composted.
•
Switch off the equipment and remove the
batteries.
•
Open the zipper on the collection bag (18)
and shake out the material.
•
Close the zipper on the collection bag (18)
again.
6.6 Clearing blockages (Fig. 19 - 21)
Danger!
•
Switch off the equipment, wait for the moving
parts to come to a standstill and remove the
batteries.
•
Wear protective gloves.
•
Use suitable tools (e.g. a wooden stick).
1. Examine the tube for blockages. Tap the
suction tube carefully or use a wooden stick
to clear any blockages.
2. The equipment is fi tted with a transparent
cover (26) in order to enable easy cleaning
and to help you remove any blockages from
the shredder. Don't forget that the shredder
can always be set in motion. Undo the cover
lock knob (27), raise the cover (26) and pull
it off . Remove any blockage with a stick if
necessary. Make sure that the shredder can
move freely and that the cover is clean.
Important. For the microswitch to remain
functional you must keep the area around the
lock knob (29) and the microswitch housing
(30) absolutely clean.
Insert the cover in the recess (28), swing it
down carefully and tighten the lock knob (27)
again.
- 14 -
05.12.2022 13:00:05 05.12.2022 13:00:05