Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT: Before installing this reverse osmosis system,
make certain your water supply complies with the following
operating specifications. Failure to do so may reduce the
effectiveness of the system and will void the warranty.
SPECIFICATIONS
Thin Film Membrane:
Feed Water Pressure:
Temperature Range:
TDS:
Maximum Hardness
:
†
Sulfide, Iron and Manganese
Chlorine in Water Supply:
pH Limits:
Daily Product Water Rate:
TDS Rejection:
If the hardness of your water is above 10 gpg (171 mg/L), lime
†
scale will build up rapidly on the membrane. Scale buildup will
plug the membrane and make the system ineffective. We do not
recommend these reverse osmosis systems to be used with
water in excess of 10 gpg (171 mg/L) hardness.
A maximum total level of approximately 0.01 ppm sulfide, iron
‡
or manganese is permissible. See your local dealer to reduce
these substances in your water.
PRODUCTION CAPABILITIES
Tested by NSF International according to NSF/ANSI Standard 58
has given 11.51 gallons per day. Source water test parameters
are 50 psig, 77°F, pH of 7.5 ± 0.5 and 750 ppm total dissolved
solids.
PARTS INCLUDED:
Pre-assembled filter system (mounting bracket, membrane
housing, membrane, pre- and post-filter housings and pre-
and post-filter cartridges).
• Reverse osmosis membrane
• Inlet supply adapter
• Drain clamp
• 1/4" Tubing
• Tank valve
TLC-50
40 to 100 psi (2.75–6.9 bar)
40–100°F (4.4–37.7°C)
2000 ppm
10 gpg (171 mg/L)
:
<0.1 ppm
‡
Less than 2 ppm
3–11
11.51 gpd (43.57 Lpd)
95.2%
(SEE BACK OF MANUAL FOR DIAGRAM)
• Storage tank
• Chrome faucet
• Feed tubing
• Sump wrenches
• 3/8" Tubing
SYSTEM DIMENSIONS:
Overall Dimensions:
13.50" W x 17.25" H x 5.50" D
(34.29 cm W x 43.8 cm H x 12.7 cm D)
Weight:
17.3 lbs. (7.84 kg)
Tank Dimensions:
13.50" W x 9.00" H x 9.00" D
(34.29 cm W x 22.86 cm H x 22.86 cm D)
Tank Capacity Max:
2.8 gal. (10.6 L)
Tank Air Pressure Empty: 5 to 7 psi (0.34 to 0.48 bar)
Tank Weight (Full):
28.5 lbs. (12.9 kg)
Tools and Materials Required
• Hand or electric drill
(cordless preferred)
• (2) Adjustable wrenches
• Slotted and Phillips screwdrivers
• File
• Safety glasses
• Drill bits: 1/8", 3/16", 1/4", 3/8"
If sink does not have hole for separate faucet:
• Center punch
• Cone-shaped grinding wheel
• 1-1⁄4" hole saw or drill bit
• Safety mask
NOTE: All tools may not be necessary for installation. Read
installation procedures before starting to determine
what tools are necessary.
PENTAIR RO-2550 Installation and Operating Instructions • 3
Publicité
