Selecting A Base Unit - Topcom Butler 4056 Mode D'emploi

Butler 4056/4056C
4.24 SUBSCRIBING BUTLER 4056 HANDSET ON ANOTHER BASE (OTHER
BRAND/MODEL)
Put the base in subscription mode (see manual of the base). If the base is in subscribing
mode, you have to do the following to subscribe the handset:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE _' appears on the display.
• Enter a number for the base unit to which you would like to subscribe the handset (1-4).
Use the number keypad.
• 'SEARCHING' and the symbol
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a
signal sounds once the base unit is found by the handset.
• Press the Programming key
• 'PIN' appears on the display.
• Enter the 4-digit PIN code of the base unit (default PIN code is '0000'). Use the number
keypad.
• Press the Programming key
• The handset is subscribed to the base unit.
4.25 REMOVING SUBSCRIPTION OF A HANDSET TO A BASE UNIT
It is possible to cancel subscription of a handset to a base unit. You would do this if a
handset is damaged and has to be replaced by a new one.
Caution: You can only cancel subscription of another handset, not the handset
you are using to do the cancellation procedure.
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'PIN' appears on the display.
• Enter your 4-digit PIN code in (default PIN code is '0000'). Use the number keypad.
• Press the Programming key
• 'REMOVE HS' appears on the display.
• Dial the number of the handset you want to remove (1 –5). Use the number keypad.
• Press the Programming key
• 'REMOVE HS' appears on the display and the handset is removed
• NOT SUB' appears on the handset removed.

4.26 SELECTING A BASE UNIT

If your handset is subscribed to several base unit stations (max. 4) , you must select a base
unit because the handset can only communicate with one base unit at a time. There are two
possibilities:
Butler 4056/4056C
.
repeatedly until 'BASE SUB' appears on the display.
.
appear on the display.
.
.
.
repeatedly until 'SETTING' appears on the display.
.
repeatedly until 'REMOVE HS' appears on the display.
.
.
.
19