PROUSER DRC4310Solar Mode D'emploi page 9

3. Adjust the camera angle
Depending if you like to put the camera on top or on bottom of the number plate you can change the
whole camera + solar panel upside down to get the right angle of the camera (camera only rotates
in one direction)
Loosen all the fixation screws and turn camera + solar upside down. Tighten the screws again when
finished.
180°
Loosen the two fixation screws and adjust the camera angle to the desired position. Check the angel
of the camera by holding the camera to the planned fixation spot on the number plate. Tighten the
screws again when finished.
9