Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Please always pair the monitor and camera before the 1
-
can be paired to the receiver.
st
-
Before the 1
operation , it is highly recommended to use the delivered micro-USB cable to fully
charge the internal battery of the camera-unit via USB (please charge for at least 5 hours with a
mobile phone adapter or a USB-powerbank). Please also make use of the USB charging socket, if your
car is parked without sunlight for a longer period of time or the internal battery is empty for another
reason.
-
Make sure the slide switch on the back of the camera unit is turned to ON-position.
-
The camera is powered by an internal battery, that can be charged by the solar cells. In the ideal
case it is not necessary to charge the camera battery after installation. Nevertheless, please
regularly monitor the battery icon on the screen and charge the battery if needed.
General use of the menus:
Press the MENU-button to show the menu. Use the UP/DOWN-buttons to select an icon and press
the ENTER-button to activate an option or enter a sub-menu. Press the MENU-button again to go
back or leave the menu.
WAKE-UP-Button
Press the WAKE-UP-Button to turn on the screen and show the camera picture. When the monitor is
connected to power, the WAKE-UP-button will be lit and the camera is activated. Press the WAKE-UP-
button again to turn off the screen.
NOTE: UNDER EXTREME BRIGHT LIGHT CONDITIONS, THE SCREEN IMAGE MAY TAKE A FEW
SECONDS TO STABILIZE. PLEASE WAIT UNTIL THE IMAGE HAS STABILIZED BEFORE BACKING UP.
MENU-button
Press the MENU-button to enter the menu screen:
Select the desired sub-menu:
Picture Specs, Picture Direction, Setup, Information.
OPERATION (Backup-Camera)
12
st
operation (see below). Max. 2 cameras
Publicité
Table des Matières
