Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
These instructions do not apply to all vehicles. They are only meant as a general guide due to the
number of different makes & models. For vehicle-specific questions contact your vehicle's
manufacturer.
Backup-Camera Installation
There are several ways to mount the camera on the back of your car. But the most convenient is to
mount it above or under the license plate.
The camera itself is mounted on the mounting plate. The camera is tiltable: the camera angle can be
adjusted manually in the vertical direction. Make sure that its field of view is not obstructed.
With some type of cars, it is not possible to mount the camera near the license plate. You may have to
find another spot at the back of your car to mount it.
1. The camera is powered by an internal battery, that can be charged by USB or the integrated solar
cells. Before installation, it is highly recommended to use the delivered micro-USB cable to fully
charge the internal battery of the camera-unit via USB (please charge for at least 5 hours with a
mobile phone adapter or a USB-powerbank). Please also make use of the USB charging socket, if your
car is parked without sunlight for a longer period of time and the internal battery is empty.
2. Make sure the slide switch on the back of the camera unit is turned to ON-position. This switch is
only used for storage purposes in order to prevent a deep discharge of the battery. While the camera
is installed at the number plate there is no use of the switch and it can be hidden behind the plate.
Note: This switch is under a rubber cover. It is a slide-switch (no button or rocker switch).
INSTALLATION
8
Publicité
Table des Matières
