Leroy Somer Control Techniques Unidrive M200 Guide Pas À Pas page 11

STEP 12: Run the motor
Action
Power Up Ensure:
• The drive displays: inh (Enable terminal(s) is open)
Minimum and Enter:
maximum speed
• Minimum speed Pr 01 (Hz)
• Maximum speed Pr 02 (Hz)
Accel and Decel rates Enter:
• Acceleration rate Pr 03 (s/100 Hz)
• Deceleration rate Pr 04 (s/100 Hz)
Motor nameplate
details
Ready to autotune
Autotune The drive is able to perform either a stationary or a rotating autotune. The motor must be at a
standstill before any autotune is enabled and disconnected from the load for a rotating autotune.
To perform an autotune:
• Set Pr 38 = 1 for a stationary autotune or set Pr 38 = 2 for a rotating autotune
• Close the drive enable signal (apply +24 V to terminal 11 or terminal 31 and 35 on
Unidrive M300). The drive will display 'rdy'.
• Give a Run command (apply +24 V to terminal 12 - Run forward or terminal 13 - Run reverse
on Unidrive M200 and M300; press keypad Start button on M201). The display will flash
'tuning' while the drive is performing the autotune.
• Wait for the drive to display 'inh' and for the motor to come to a standstill.
• Remove the drive enable and run signal from the drive.
Ready to run
Run The drive is now ready to run the motor. Close the Run Forward or Run Reverse terminals on
Unidrive M200 and M300; press keypad Start button on M201.
Increasing and Changing the selected Analog frequency reference (Speed Ref Potentiometer on M201)
decreasing speed will increase and decrease the speed of the motor.
Stopping To stop the motor by following the selected deceleration rate, open either the run forward or run
reverse terminal on Unidrive M200 and M300; press keypad Stop button on M201. If the enable
terminal is opened while the motor is running, the drive output is immediately disabled and the
motor will coast to a stop.
Troubleshooting
When the drive detects a fault it will display an error code. To locate and solve all error codes, a 'Diagnostic Tool
(App)' is available on Microsoft, Android and iOS platform via the 'Apps' store on Smartphone / Tablet, search for
'Control Techniques diagnostics tool in the Apps store'.
Alternatively, please download the 'Diagnostic Tool (App)' from the Control Techniques 'App Center' or view the
diagnostics section in the Control Quick Start Guide available for download from the Control Techniques or Leroy
Somer website.
Unidrive M200/M201/M300 Step By Step Guide
Issue Number: 1
All manuals and user guides at all-guides.com
Motor rated current in Pr 06 (Amps)
Motor rated speed in Pr 07 (rpm / min
Motor rated voltage in Pr 08 (Volts)
Motor rated power factor in (cos
Detail
-1
)
φ
) Pr 09
MOT. 3 LS 80 L T
N
9
734570 BJ 002 Kg
IP 55 I cl.F 40 C S1
V Hz min -1 kW cos A
230 50 2800 0,75 0,83 0,3
3 2 4 1
11