Publicité
Les langues disponibles
Les langues disponibles
B
3. Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to
adjust the consumption by user. Follow the below steps.
1. Close the door, switch on the appliance.
2. Within 60 seconds after step 1, press the Program button more than 5 seconds, and then
press the Delay start Button to enter the set model, the rinse aid indication blinks as 1Hz
frequency, the default setting is d3.
3. Press the Program button to select the proper set according to your using habits ,the sets
will change in the following sequence: d3->d4->d5->d1->d2->d3, The higher the number, the
more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or Press the Power button to end the setup model.
Using the appliance
Rinse aid level
D1
D2
D3
D4
D5
29
Selector position
Rapid Light bright
90 min Light bright
90 min, Rapid Light bright
Glass Light bright
Glass, Rapid Light bright
EN
Publicité
