Publicité
Les langues disponibles
Les langues disponibles
B
• Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on, press the Programme button for
more than 5 seconds to start the water softener setting mode;
3. Press the Program button again to select the proper setting according to your local
environment, the setting will change in the following sequence: H3->H4->H5->H6->H1->H2;
4. Without operation in 5 seconds or Press the Power button to end the setup model.
WATER HARDNESS
German
French
dH
fH
0 - 5
0 - 9
6 - 11
10 - 20
12 - 17
21 - 30
18 - 22
31 - 40
23 - 34
41 - 60
35 - 55
61 - 98
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l
The factory setting: H3
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
1)
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
Using the appliance
British
Mmol/l
Clarke
0 - 6
0 - 0,94
7 - 14
1,0 - 2,0
15 - 21
2,1 - 3,0
22 - 28
3,1 - 4,0
29 - 42
4,1 - 6,0
43 - 69
6,1 - 9,8
23
Regeneration
Water softner
occurs every X
level
program sequence
H1- Rapid Light
No regeneration
bright
H2- 90 min Light
bright
H3- 90 min,
Rapid Light
bright
H4- Glass Light
bright
H5- Glass, Rapid
Light bright
H6- Glass, 90
min Light bright
EN
Salt consumption
(gram/cycle)
1)
0
10
9
5
12
3
20
2
30
1
60
Publicité
