Thermador PROFESSIONAL PRO GRAND PRD36 Manuel D'installation page 24

1. Tape the templates included with the Keep Hot Shelf to
the wall accordingly:
• Tape the sheet titled Left Hand Template to bottom
and left end of hood. Align the bottom line of hood
with the top line of the template.
• Tape the sheet titled Right Hand Template to
bottom and right end of hood. Align the bottom line
of hood with the top line of the template.
• Tape the sheet titled Installation Instruction so that
the arrow at the top of the template aligns with
hood centerline. Align the bottom line of the hood
with the top line of the template.
• Left to right sides of the template must be equal to
length of shelf.
2. Mount the (2) top shelf brackets and the (3) lower shelf
brackets at the locations outlined on the templates.
Secure with (10) 1" (25.4mm) screws provided.
3. Cut template out from around the brackets and remove
from the wall. Do not discard template before the Keep
Hot Shelf is completely installed.
4. Insert (3) U-Nuts onto the (3) lower shelf brackets.
English 22
5. Install the wall plate by setting the corner notches
(back of wall plate) atop the (2) top shelf brackets.
Slide the shelf upwards until the bottom engages with
the (3) lower brackets (Figure 20).
Upper shelf bracket (x2)
6. Check if the top is properly secured by pulling the top
section of the shelf from the wall.
7. Secure to bottom of shelf with the (4) 1/2" (12.7mm)
screws provided.
For 48" Keep Hot Shelf
Follow steps 1-6 except use (4) lower brackets which must
be spaced equally 15" (381mm) center-to-center.
Notches (x2)
Lower shelf bracket (x4)
Figure 20: 48" Back of Wall Plate