Publicité
Les langues disponibles
Les langues disponibles
EN
Preparation and start-up
1. The area where the air compressor will be installed should be clean, dry and well ventilated.
2. Use current with the correct voltage, deviation ±5%.
3. Keep the oil level at the red indicator.
4. Recommended oil for the compressor is SAE30 or L-DAB100 when the temperature is above 10o C and SAE10 or L-DAB68 when the temperature is below
10 0C.
5. Open the exhaust valve, place the pressure switch in the ON position. Allow the air compressor to run for 10 minutes without load to confirm lubrication
on moving parts.
6.Check the belt tension: it is correct when you can push the belt with your finger 10-15mm downwards, in the centre of the belt.
7.Select the correct power supply according to the information on the motor nameplate.
Operation and adjustment
The compressor is controlled by the pushbutton when it is operating normally. It can stop automatically when the pressure rises to the maximum and start
when the pressure drops to the minimum. The pressure value is set at the factory. Do not change it. Once the engine is turned off the compressed air in the
exhaust pipe should be released through the release valve under the switch. It is a necessary point for starting or the motor may be damaged. The pressure
value can be adjusted by turning the adjusting screw on the switch (figure 1 or figure 2).
Fig.1
Fig .2
ATTENTION
1. Do not unscrew any part of the connection when the container is under pressure.
2. Do not dismantle any electrical part before unplugging.
3. Do not adjust the valve without care.
4. Do not use the machine where the voltage is too low or too high.
5. Do not use the metal part or electric cable smaller than 4mm
and more than 5m long.
2
6. Do not unplug the socket to stop the machine. Set the switch to the Off position.
7. If release valve does not operate as the motor stops find the cause immediately to prevent damage to the motor.
8. The lubricating oil should be clean. The level should be at the red point.
9. Unplug the cord when you finish using it.
10. Τhe safety valve and parameters have been set according to the working conditions, do not change them.
Maintenance
In terms of maintenance, the following are recommended:
- Clean the box and change the lubricating oil after the first 20 hours of operation.
- Check the oil level every 20 hours of operation and top up if necessary.
- Open the drain plug under the reservoir every 60 hours of operation.
- Clean the box, change the oil, clean the air filter and check the safety valve and pressure indicator after 120 hours of operation.
5
WWW.NIKOLAOUTOOLS.GR
Publicité
