HOMCOM 823-041V80 Manuel D'instructions page 17

Note:
- Pull out the filter gently.
- Remove the filter from the back panel first, then remove the filter from the side panel -
this will stop the filters from being twisted or damaged.
- Do not squash or hit the mesh with sharp objects or brushes.
- Do not use the appliance without installing the filter.
INTERNAL WATER TANK
The 'Water Full' indicator illuminate when water has exceeded the limit.
To Empty the Internal Water Tank:
1. Turn off and unplug the unit.
2. Place a pan (not included) below the lower drain, which is on the back (near the
bottom) of the air conditioner.
3. Remove the cap and the rubber plug, then drain the water tank.
4. Reinsert the drain plug and screw the cap tightly.
5. Plug in and turn on the unit.
STORAGE
Please store the air conditioner properly if not in use.
1. Screw off the drain cover and pull out the stopper to drain water completely. Or tilt the
unit to drain water.
2. Keep unit running in 'Fan' mode for half a day to dry inside of unit - this will prevent
mould.
3. Turn off the unit, pull out plug and wrap the power cord around the wire-winding pillar,
insert the plug into the universal
fixing hole at the back panel of the unit, then install the water stopper and drain cover.
4. Remove the heat exhaust hose to clean properly.
5. Take out the batteries from remote controller and place it in the box.
Note:
Store the unit in a dry location. Keep all accessories safe and together. Keep the unit out
the reach of children.
17