Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL
1) Power on and off: When the unit is plugged in, press the 'P' button to
turn on the unit. Press again to turn the unit off.
2) Mode Selection: Press the Cool, Dry or Fan mode.
3) Fan Speed: Press the High or Low button to adjust the fan speed.
When the unit is in Dehumidifier mode, the fan speed cannot be
changed.
4) Temperature Setting: When the unit is in cool mode, you can select
your desired temperature. Press the ▲ or ▼ to select your desired
temperature setting.
5) SLEEP MODE: When in air conditioning mode, press the SLEEP
Button on the remote control.
6) TIMER
Auto-On: Press the TIMER button when the unit is off to set up the
Auto-on timer. Press the ▲ or ▼ to set timer within 1-24 hours.
Auto-Off: Press the TIMER button when the unit is On to set up the
Auto-off timer. Press the ▲ or ▼ to set timer within 1-24 hours. To
cancel the timer, press the TIMER button until it is turned off.
7) ºC/ ºF
Press this button to switch temperature unit.
NOTE:
● Insert the two AAA batteries.
● Do not use rechargeable batteries.
● When replacing the battery, replace the two batteries at
the same time. Do not mix old and new batteries.
● If you do not use this unit for a long time, please take out
the battery of the remote control and store it properly.
WARNING
● If the battery liquid of the remote control leaks on your skin or clothes, please rinse with
plenty of water as soon as possible; if you find a leak, please do not use the remote
control.
● If you swallow the battery liquid, rinse your mouth and seek medical attention as soon
as possible. The chemical substances in the battery may burn or cause other health
hazards.
SAFETY PROTECTIONS
1. Water full safety alarm and shut off protection function
When the water volume exceeds its alarm level in chassis, the 'water full' icon will light.
You need to drain the water and restart the unit. For more information about how to drain,
refer to the 'Drainage' instructions. If the unit is not shut down manually, it will go to its
original operating status automatically once the water is fully drained. Or connect the
power to restart the unit again.
14
Publicité
