HOMCOM 823-041V80 Manuel D'instructions page 16

Notes:
● Protect the drain cover and water stopper properly.
● Move the unit carefully to avoid leakages.
● Tilt the unit slightly backwards when draining.
● Block the drain hole as soon as possible before the tray is full.
● Water stopper and drain cover must be tightly installed.
CONTINUOUS DRAINAGE
1. Screw off the drain cover and unplug the water stopper.
2. Connect the drain hole with the φ13mm drain hose (if you need the plastic drainage
pipe, please purchase it with an outer diameter of 13mm and length according to the
drainage distance), as deep as possible to avoid a leakage.
3. Pull the drain hose to the bathroom or outdoors.
Notes:
● Drain hose must be installed when there's no water in
the tray.
● It is not recommended to drain when the unit is in
'COOL' mode, keeping enough water in the unit to
enhance the system cooling effects.
● It is suggested that to adopt continuous drainage when
unit is in 'HEAT' mode to avoid frequent drainage.
● Put the drain hose in an inaccessible place, not higher
than drainage hole and keep drain hose straight.
CARE AND MAINTENANCE
WARNING
Before cleaning and maintenance, turn off and unplug the unit.
SURFACE CLEANING
- Unplug the appliance before cleaning.
- Clean the unit surface with a damp and soft cloth - do not use chemical solvents such as
alcohol and gasoline. Any thinner, alcohol-glazer or other similar solvents is prohibited
for unit cleaning.
- Clean the air outlet or louvers with a damp cloth and detergent. Any chemical solvent is
prohibited to use for unit cleaning. Keep all chemical solvents away from the unit.
FILTER CLEANING
- Clean the filter once every two weeks for normal operation.
- Grip the filter handle and pull it out gently in the correct direction.
Clean the dirty particles in the filter by cleaner if necessary.
Immerse and wash the filter gently with warm water (about 40ºC)
mixed with neutral cleaner, then rinse and dry them thoroughly in
the shade.
16