Publicité
Les langues disponibles
Les langues disponibles
5.2.2
Assembling the interior cabinet type 3
5. Assembling the interior control cabinet
Lastly, the cabinet is fitted into the previously drilled
holes using the M8 (rough) bolts.
Alternative:
First screw the M8 bolts up to 15 mm into the wall,
then use the slots to hook the cabinet into the wall
brackets.
The control cabinet is supplied with the rubber-metal
buffers pre-assembled. During installation, ensure
that the location is stable (e.g. table), horizontal and
level. An additional fixation is not necessary.
/
The wall brackets
are to be attached
at the holes in the
cabinet as shown in
the illustration. The
brackets are fixed
with the four M8
(fine) bolts and the
corresponding
washers and nuts.
Note
For cabinets with
Becker
compres-
sors, the brackets
are
already
pre-
assembled
Publicité
