Thetford C-250 Instructions D'utilisation page 3

UK
Instructions for Use
INTRODUCTION
The Thetford Cassette Toilet is a high quality product. The
toilet forms an integral part of your caravan or camper
q
bathroom, thanks to its functional design which combines
modern styling and ease of use. The C-250 Cassette Toilet
is manufactured from high quality synthetic materials which
makes it a durable, user and maintenance friendly toilet.
The toilet is made up of two parts: a permanently fi xed part
and a Waste Holding Tank that is accessible from the outside.
The removable Waste Holding Tank is located under the
toilet bowl and can be removed via a door on the outside of
the caravan or camper. The Thetford Cassette Toilet is the
solution to the sanitary problem in your caravan or camper!
The operating instructions in this Owner's Manual cover
Thetford Cassette Toilet models C-250S, C-250CS (models
connected to the vehicle's central water tank) and C-250CWE
(model with its own fl ush-water tank). There are differences
in the use of these models. Please ensure that you follow the
instructions that apply to your toilet model.
PARTS
a) Removable Seat and Lid
b) Swivelling Toilet Bowl
c) Blade Handle
d) Flush Button
e) Waste Holding Tank Level Indicator
f) Water Filling Door (only if toilet has own fl ush-water
tank)
g) Rotating Emptying Spout
h) Automatic Pressure Release Vent
i) Sliding Cover
j) Removable Mechanism
k) Vent Plunger
l) Pull-Out Handle
m) Wheels
n) Blade Opener
o) Access Door to Waste Holding Tank
Optional Features
p) Electric Blade
q) Automatic Ventilator
r) Waste Pump-Out System
s) Waste Holding Tank Multi-Level Indicator
t) Flush-Water Tank Level Indicator (only if toilet has its
own fl ush-water tank)
Note. Optional features can be bought from Thetford
dealerships.
PREPARING FOR USE
1. Open the access door on the outside of your caravan or
camper.
2. Remove the Waste Holding Tank by pulling the safety
catch (which holds the tank in place) upwards.
O
3. Pull the Waste Holding Tank outward to the stop. Tip it
4. Place the tank upright and turn the rotating emptying
5. Remove the cap, with the measuring cup inside, from the
6. Slide the Waste Holding Tank back into its original
7. For toilets with own Flush-Water Tank: Open the water
Preparing for use with Optional Features
8. Automatic Ventilator: Open the access door on the
9. Remove the fi lter housing cover and if no fi lter is present,
USING THE TOILET
10. Turn the bowl to the desired position with the lid closed
11. To activate the control panel, press the fl ush-button
12. The toilet may be used with the blade open or closed.
(standard)
- 3 -
slightly and take the tank fully out.
spout upwards. The emptying spout ensures that the tank
can be easily and hygienically emptied.
emptying spout and pour the correct dosage of Thetford
toilet fl uid (see product label) into the holding tank. This
avoids unpleasant smells and keeps the inside of the tank
clean. Next add approximately 2 litres of water - enough
to ensure that the bottom of the Waste Holding Tank is
covered. For more information on Thetford toilet fl uids,
see last page of this manual. Screw the cap back onto the
emptying spout and turn back to its original position.
Note. The Emptying Spout Measuring Cap is supplied in
the same packaging as this manual.
Warning! Never add toilet fl uid directly via the blade
or the toilet bowl as this could damage the lip seal of
the Waste Holding Tank. Always pour the fl uids via the
emptying spout.
position via the access door.
Make sure that it is secured with the safety catch. Close
the access door and lock it. Your Thetford toilet is now
ready to use.
Warning! Never use force if you cannot get the tank
back into place easily. This may cause serious damage.
If blockage occurs, always check if the blade handle is in
the correct (closed) position.
fi lling door and fi ll the fl ush-water tank with the correct
dosage of Aqua Rinse. This Thetford toilet fl uid keeps the
fl ush water fresh and improves the fl ushing. Next, fi ll up
the fl ush-water tank with clean water (approximately 8
litres) using a jerry can or hose. Your toilet is now ready
to use.
outside of your caravan and remove the Waste Holding
Tank (as described above).
place a new fi lter into the fi lter housing. Peel off the
sticker lids on the fi lter. Place back the cover of the fi lter
housing.
(standard)
and using both hands.
once. The control panel display will stay activated for
approximately 5 minutes. Run some water into the bowl
by pressing the fl ush button again briefl y.
To open the blade, slide the blade handle under the
toilet bowl sideways. After use, open the blade (if still
closed) and fl ush the toilet by pressing the fl ush button
for several seconds (if necessary re-activate the control
panel). Close the blade after use.
UK