Seca 664 Mode D'emploi Et Garantie page 74

5.2 Assembling the device
Fitting the column
You need the following connecting elements for this
assembly step:
2 x hex socket head screws
1. Route the display cable so that it cannot get
trapped when you fit the handrail.
2. Place the column against the handrail as shown in
the diagram above.
3. Put one serrated lock washer on each of the
screws.
4. Put the screws in the bores on the handrail and the
column.
5. Tighten the screws.
Before you really get started... • 73
English
2 x serrated lock
washers