Dometic DrawBar5S Notice D'utilisation page 19

6. Close the drawer.
Installing the overlay panel
(DrawBar5S only)
See fig. b, page 9
I
NOTE
Ensure the measurements of the overlay
panel are suitable for the selected instal-
lation location.
1. Install the cabinet handle on the overlay panel.
2. Pull out the drawer and remove the door
gasket to reveal the fastening holes.
3. Fasten the overlay panel to the drawer door
using the supplied screws.
➤ Check for correct alignment after fastening
each screw.
4. Reattach the door gasket and close the
drawer.
Description of the device
No. in
fig. c,
Explanation
page 10
1 Temperature indicator LEDs
2
On/off button
3
Setting button
4 Glass front panel with handle
(DrawBar5B, 5C only)
5 Humidity tray
6 Interior LED lamp
7 Rubber strips
EN
Operation
Before first use
➤Clean the wine cooling drawer inside and out-
side for hygienic reasons (see chapter "Cleaning
and maintenance" on page 21).
➤Fill the humidity tray with water at least until the
sponge is completely covered (fig. i,
page 11).
Saving energy
• Only open the wine cooling drawer as often and
for as long as necessary.
• Avoid unnecessarily low temperature settings.
• On a regular basis, make sure the drawer seal still
fits properly.
• Clean dust and dirt from the condenser at regu-
lar intervals.
Switching on and off
➤To switch on, press the
page 10).
➤To switch off, press and hold the
at least 2 seconds (fig. e, page 10).
Setting the temperature
To avoid food waste, note the following:
• Keep temperature fluctuation as low as possible.
Only open the wine cooling drawer as often and
for as long as necessary. Store the wine bottles in
such a way that the air can still circulate well.
• Adjust the temperature to the quantity and type
of the wine bottles.
The wine cooling drawer is set by default to a cool-
ing temperature of 11 °C.
➤To set the temperature, press the
repeatedly until you reach the desired tempera-
ture level (fig. f, page 10).
4445103438
button once (fig. d,
button for
button
19