Dometic DrawBar5S Notice D'utilisation page 18

Installation
Observe the following instructions when selecting
an installation location:
• Observe the product dimensions and the neces-
sary installation space to ensure a proper fit
(fig. 2, page 4, fig. 3, page 4).
• Observe the warnings when connecting the
supply cord (fig. 4, page 5).
• Ensure the mounting surface is solid, level and
clean (fig. 5, page 6).
• Do not install the wine cooling drawer on top of
an appliance (fig. 6, page 6).
If the wine cooling drawer is intended to be built
into a high cabinet with an appliance, it can be
installed underneath without the need of an interim
shelf.
Preparing the cabinetry
There are two installation options for the wine
cooling drawer:
• Into a high cabinet with an appliance
(fig. 3 A, page 4).
In this case proceed with the instructions in
chapter "Open-back high cabinet with appli-
ance" on page 18.
• Underneath a counter (fig. 3 B, page 4).
In this case proceed with the instructions in
chapter "Closed-back counter or cabinet" on
page 18.
Open-back high cabinet with appliance
I
NOTE
If the clearance between the cabinetry
and the rear wall is less than 35 mm a
proper air circulation is not guaranteed
and the wine cooling drawer will con-
sume more energy.
➤Ensure a clearance of at least 35 mm between
the high cabinet and the rear wall.
18
Closed-back counter or cabinet
See fig. 7, page 7
I
NOTE
If the clearance between the cabinetry
and the rear wall is less than 35 mm a
proper air circulation is not guaranteed
and the wine cooling drawer will con-
sume more energy.
1. Ensure a clearance of at least 35 mm between
the cabinetry and the rear wall.
2. Make a 60 x 180 mm cut-out in the back of the
shelf.
3. Make a 200 mm wide cut-out in the back wall
of the cabinetry. The hight of the cut-out
should be the distance between the shelf and
the counter-top.
4. Cut the short baffle sponge to an appropriate
size to fit the gap between the fan and the
back of the cabinetry.
5. Insert the baffle sponge between the fan and
the back of the cabinetry so that it fits tightly.
6. If the clearance between the top of the wine
cooling drawer and the cabinetry is larger than
10 mm, insert the long baffle sponge.
Cut the baffle sponge if necessary and put it
on top of the wine cooling drawer.
Mounting the wine cooling drawer
1. Attach the mounting plates to both sides of
the product housing using the supplied
screws.
If necessary, use a suitable combination of
supplied spacers to ensure a proper fit
(fig. 8, page 8).
2. Plug in the supply cord.
3. Fully pull out the drawer and lift it off the slid-
ing rails (fig. 9, page 8).
4. Secure the product housing to the walls of the
cabinetry using the supplied screws and
washers (fig. 0, page 9).
5. Fully extend the sliding rails and carefully place
the drawer back onto the sliding rails (fig. a,
page 9).
4445103438
EN