Publicité
Les langues disponibles
Les langues disponibles
Note: Clean the threads on the adapter and seals thoroughly to avoid ingredient build up.
Ingredient build up might cause problems when trying to remove the blade base from the
personal cup if it has been attached and allowed to sit for a long period of time.
Dishwasher:
The cup, lid, adapter and seals are dishwasher safe.
In-place Cleaning:
1. Fill the container half full with water and add a couple of drops of dishwashing liquid. DO NOT BLEND HOT
WATER.
Put a seal on the bottom thread of the adapter. The seal should fit snugly and evenly around the thread.
2.
Thread the adapter onto the cup in a clockwise direction just until tight. Put the cup and adapter onto the
base.
3. Use Variable Speed:
Press Start / Stop.
a.
Slowly increase variable speed to 10.
b.
Run the machine for 60 seconds.
c.
d.
Rotate the Variable Speed dial back to Variable 1. Press Start / Stop.
4.
Rinse and drain all pieces.
To Sanitize:
1.
Follow the cleaning instructions above.
2.
Fill the container half full with water and 1/2 teaspoons of liquid bleach. DO NOT BLEND HOT WATER.
Put a seal on the bottom thread of the adapter. The seal should fit snugly and evenly around the thread.
3.
Thread the adapter onto the cup in a clockwise direction just until tight. Put the cup and adapter onto the
base.
4.
Use Variable Speed:
a.
Press Start / Stop.
b.
Slowly increase variable speed to 10.
Run the machine for 60 seconds.
c.
Rotate the Variable Speed dial back to Variable 1. Press Start / Stop.
d.
Allow mixture to stand in the container for an additional 1 ½ minutes.
5.
Pour bleach mixture out. Allow container to air dry. Do not rinse after sanitizing.
6.
Motor Base
1.
Unplug the power cord.
Electrical shock hazard.
Disconnect power before cleaning machine. Do not immerse or
place the motor base in water.
Failure to follow instructions can cause death or electrical shock.
2.
Wash the outside surface with a damp soft cloth or sponge, which has been rinsed in a mild solution of
liquid detergent and warm water.
3.
Thoroughly clean the variable speed dial so it works freely. Moisten a cotton swab with a household
degreaser or cleaner and clean the grooves around the control.
4.
Moisten a cotton swab and wipe out the overflow opening at the back of the motor base.
5.
Immediately dry all surfaces. Polish surfaces with a soft cloth.
12
C
C
a r e a n d
WARNING
l e a n i n g
Publicité
