Product Description; Specifications; Flow Rate - Franklin Electric FPS IGP-A Serie Manuel Du Propriétaire

PRODUCT DESCRIPTION

Submersible grinder pumps are recommended for use in basins or lift stations and are suitable for pumping
residential sewage, effluent, wastewater, and other non-explosive, non-abrasive, and non-corrosive liquids.
These pumps utilize a cutting mechanism, located on the suction side of the pump, that cuts solids into a
slurry. A semi-vortex, non-clog impeller then passes this slurry directly through the volute and into the dis-
charge line.
Some FPS IGP series grinder pumps are equipped with a float switch that allows the pumps to operate auto-
matically by cycling them on and off. The float switch is attached to the pump at a pre-determined tether
length of 9 inches (22.86 cm). Check the tether length on the pump to ensure it has not changed during
shipping.
This product is covered by a Limited Warranty for a period of 2 years from the date of original purchase by
the consumer. For complete warranty information, refer to www.FranklinEngineered.com.

Specifications

Model No. Volts
IGP-A231-20
IGP-A231-30
IGP-M231-15 208-230
IGP-M231-30
IGP-M233-30
IGP-M463-30 460
NOTE: IGP-A models can be ordered without automatic floats.

Flow Rate

10 ft 20 ft
(3.0 m) (6.1 m)
33 / 124.9 32 / 121.1
Amps
13.9
10
4.5
Gallons (Liters) per Minute at Height
40 ft 60 ft
(12.2 m) (18.3 m) (24.4 m)
31 / 117.3 30 / 113.6
Watts HP
3200
2
1300
1025
80 ft 100 ft
(30.5 m) (36.6 m)
25 / 94.6 20 / 75.7 10 / 37.9
PRODUCT DESCRIPTION
Phase
1
3
Shut-Off
120 ft
(ft / m)
130 / 39.6
Specifications
3