Festo DGP B Série Notice D'utilisation page 33

DGP(L)−...−B
Commissioning the DGP(L)− as a servopneumatic positioning axis:
Please note
Complete commissioning in accordance with the specifications for your
positioning system.
Commissioning the DGP(L)−... as a cylinder:
1. Close all the one−way flow control valves
at first completely,
then loosen them one turn.
2. Close the adjusting screws for the end
position cushioning on both sides
at first completely,
then loosen them one turn.
3. Pressurize the DGP(L)−... at first on both sides simultaneously.
The slide will then move forward slightly to a centre point of equilibrium.
4. Then exhaust the DGP(L)−... on one side.
In this way you can avoid peak loadings on the DGP(L)− and in the
compressed air network.
5. Start a test run.
6. Check to see if the following settings on the DGP(L)−... need to be modified:
the slide speed
the end position cushioning (not with DGP(L)−8/12).
Mass geometries with projection in the direction of the slide movment
Warning
Note that the adjusting screws must only be
turned when the DGP(L)−... is at a stand.
Festo DGP(L)−...−B 0407f English
Fig. 26
Fig. 27
Fig. 28
33