Instrukcja Obsługi; Transportation And Storage; Cleaning And Maintenance - Royal Catering RCHG-11WO Manuel D'utilisation

Before the first use, wash the entire device thoroughly, as specified in item CLEANING AND MAINTENANCE
hereof.
Place the device on a flat surface, capable of supporting its weight and resistant to high temperatures. Ensure
good ventilation in the room where the device is to be operated. The power plug must be easily accessible
in case the device must be switched off in emergency. The device must be earthed. The grounding screw
is located at the rear of the device; use it to attach the earth conductor as per relevant safety regulations.
Make sure the temperature adjustment knobs (3), (5) and (7) are set to OFF (heating disabled).
Connect the device to the mains and turn it on with the main switch (1). Put the sausages on the rollers,
set the appropriate temperature of the front (3) and/or rear (5) rollers. Additionally, if necessary, set the
appropriate temperature inside the drawer using the knob (7). After setting the temperatures, the respective
indicator lights (2), (4), and (6) will turn on, when the pre-set temperature is reached, the lights will go out.
When the temperature drops, the thermostat will activate heating and the indicator lights will come on
again. After finishing work, set all the temperature adjustment knobs to OFF, disable the device with the main
switch (1), disconnect it from the mains and, once it cools down, clean it thoroughly.

TRANSPORTATION AND STORAGE

During transport, the machine should be protected from shaking, falling and turning upside down. Store it in
a properly ventilated place with dry air and without any corrosive gas.

CLEANING AND MAINTENANCE

• Always unplug the device before cleaning it and after each use.
• Use cleaner without corrosive substances to clean surface.
• After cleaning the device, all parts should be dried before reusing it.
• Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
• Never spray the device with water jets.
CHECK REGULARLY THE DEVICE
Check regularly the machine for signs of damage. If the machine is damaged, please stop using it immediately
and contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare the following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, take a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determine the source of the problem if you
give a detailed and precise description of the matter. The more detailed your information, the better
customer service will be able to solve your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
10
INSTRUKCJA OBSŁUGI
 R C H G - 1 1 WO
R C H G - 9 WO

Rev. 18.05.2017
expondo.de