Instrukcja Obsługi - Royal Catering RCPS-16E Manuel D'utilisation

5. You can repeat this procedure as often as you want to. It only takes approximately 2 minutes until
the corn pops steadily.
6. Do not let any oil drop on the hot plate as it can result in a fire. WARNING: Do not let any water
drip on the plate during the popcorn popping procedure.
7. The device is equipped with a thermostat. If the temperature exceeds the maximum the machine
switches off automatically to ensure the required safety.
Attention: The pot has to be emptied and the heating turned off as soon as the frequency (approx. 2-3
seconds) of popping slows down. Only like this, burning of sugar and popcorn as well as damage to the
coating can be prevented. It is not always possible for all corn to pop.
Remove residues after every production cycle.
We cannot assume liability for damages to the pot's coating due to improper use.
CLEANING AND MAINTENANCE
1. Switch off the device and disconnect the power plug in order to prevent accidents when cleaning
the machine.
2. To clean the device from the outside, use a wet cloth with some corrosion protection. DO NOT
clean the machine with water as it can damage the electric function of the device.
3. If the device is not used for a prolonged period of time, unplug the power plug.
4. DO NOT clean the inside of the device with hard metallic objects, as this will damage the coating
of the machine.
REGULAR CONTROL OF THE DEVICE
Control regularly that the device does not present any damage. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determine the source of the problem if you give a
detailed and precise description of the matter. Avoid formulations like "the device doesn´t heat", which
may mean that it does not heat enough or even not at all. These failures have different causes!
• The more detailed your information, the better the customer service will be able to solve your problem
rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a
loss of warranty!
TROUBLESHOOTING
Problem Causes
No light Power plug is not connected
No heating 1. Loose cable at the popcorn bowl
2. Heating tube has blown
3. Electrical connection is interrupted
Temperature is too high or too low Thermostat failure
ATTENTION
Before usage please remove the adhesive tape from the mixing arm which is located inside of the bowl.
12
Possible remedies
1. Fasten the cable
2. Replace bulb
1. Tighten the screws
2. Replace the heating pipe
3. Change the electrical capacity
Change the thermostat
Rev. 01.08.2017
INSTRUKCJA OBSŁUGI
MASZYNA DO POPCORNU
Nazwa produktu: Maszyna do popcornu
Model produktu: RCPS-16E | RCPR-16E | RCPW-16E |
RCPC-16E | RCPW-16.1 | RCPR-16.I
RCPW-16.2 | RCPW-16.3 | RCPS-16.2 | RCPR-16.3
Nazwa producenta: expondo Polska sp. z o.o. sp. k.
Adres producenta: ul. Dekoracyjna 3, 65-155 Zielona Góra | Poland, EU
expondo.de