DeWalt D26411 Traduction De La Notice D'instructions Originale page 26

EngLIsH
Constant Heat Control (Overload Protection)
When the tool is overloaded, this feature protects the heating
element from damage without stopping the tool and/or
without a cool down period.
1. When the temperature gets too hot, the heating element
switches itself off. The motor will continue to run and
produce cold air.
2. When the temperature has cooled sufficiently (taking
only a few seconds) the heating element will switch
on automatically.
Tool Ring (Fig. A)

WARNING: ALWAYS turn heat gun off, disconnect from
the power source and let the tool cool down for at least 30
minutes before moving or storing it.
For easy storage, the tool can hang from the tool ring
heat gun should be stored indoors.
Cool Down Period
The nozzle and accessory becomes very hot during use. Turn
heat gun off, disconnect from the power source and let the tool
cool down for at least 30 minutes before moving or storing it.
nOtE: To reduce the cooling time, switch the tool on at the
lowest air temperature setting and let it run for a few minutes
before turning the heat gun off.
MAINTENANCE
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
24
Optional Accessories

WARNING: Since accessories, other than those offered
by D
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
6
. The
according to local provisions. Further information is available at
www.2helpU.com.
WALT, have not been tested with this product, use
e
WALT recommended
e