Jacuzzi J-400 Serie Manuel D'installation Et Utilisation & Entretien page 76

"PROCLARITY DEPTH FILTER REMINDER"
Reminder
It's time to replace your
ProClarity Depth filter.
Contact your authorized
dealer for a new filter.
reset snooze
This message will appear when the filter reminder time has
expired.
I
The ProClarity Depth filter must be replaced.
"WATER REFRESH REMINDER"
Reminder
This is a general
reminder. Please change
your water soon.
reset snooze
This message will appear when the "Water Refresh" timer has
expired.
I
The water needs to be drained and refilled with fresh water.
"EXTENDED TEMPERATURE ACTIVATED"
The spa is set to go up to 40°C (104°F), but it can be set to reach
41°C (106°F). To access the extended temperature you need press
and hold your finger over the temperature reading for about 5
seconds. The temperature reading will start to blink to indicate
the system is ready. Tap (
41°C (106°F).
Note: The heater icon (
the feature is active.
Troubleshooting Procedures
In the unlikely event your spa is not working the way you believe it
should, please first review all the installation and operating instruc-
tions in this manual and check the message on the panel display;
second, if you are still not satisfied it is working properly, please
follow the appropriate troubleshooting instructions.
NONE OF THE COMPONENTS OPERATE
(i.e. pump, light)
Check the control panel lights.
I If there are letters or symbols displayed on the screen, refer to
the previous section (Error/Display Messages) to determine mean-
ing and action required.
I If nothing appears on the display:
- Check the household circuit breaker.
- Contact dealer or authorized service center.
PUMP DOES NOT OPERATE
Activate the "JETS"
) to raise the temperature up to
ON
) will be blinking to indicate that
I If no sound is detected or if you can hear a buzzing noise,
disconnect the power supply and contact an authorised
Jacuzzi® service centre.
I If motor operates but no water flows to jets:
- Pump may not be properly primed. See instructions below.
- Contact an authorised Jacuzzi® retailer or service centre.
Pump priming instructions:
TURN SPA OFF
- Turn off the power to the spa.
- Remove the handle from the massage selector supplied by
the pump you are priming.
- Loosen the massage selector's cap slightly (counterclock-
wise), listening for the air to seep out.
- Tighten the cap finger-tight, replace the handle and turn
the hot tub's power back on.
Note: This method must be used for the jet's pumps because
these pumps are not connected to the main filter system in any
way.
CAUTION: If freezing conditions exist and pump is not opera-
tional, take measures to protect the system from possible dam-
age from freezing. See "Winterizing".
POOR JET ACTION.
- Make certain the jets pump is turned on.
- Check position of massage selectors.
- Open air control for selected jet system.
- Check for adequate water level.
- Check for dirty filter
WATER IS TOO HOT.
- Reduce thermostat setting.
- Switch hot tub to "Econo" mode to turn heater on only dur-
ing pre-programmed time.
- Make sure the pumps are turned off and not constantly run-
ning.
NO HEAT
- Check thermostat setting.
- Keep the cover in place while heating.
- If heater indicator is displayed, but no temperature increase
is experienced after a reasonable period of time, contact
your dealer or authorized service center.
FILTER/CIRCULATION PUMP OFF
- Verify filter/circulation pump is programmed to run 8 hours
a day.
- Make sure there are no errors preventing the pump from
turning on.
- Hot tub water is warmer than 95°F (34°C) and two degrees
warmer than the set temperature. The "Summer Logic" safety
feature has activated ((see the relevant section)).
76