Amann Girrbach smartmix X2 Mode De Fonctionnement page 13

storIng mIxIng Programmes
The user interface of the Smartmix X2 comprises
two levels: The working level of the mixing
programs 1 - 20 and the programming level for
defining the stirring parameters for the individual
program. Press the turning-pushing knob (B) for
1.5 sec to change between the two levels. Turn
the turning-pushing knob to change the individual
setting.
how to change between the two menu levels:
1. Change from the working level to the program-
ming level: Press the turning-pushing knob
for 1.5 sec to get into the programming level,
where stirring parameters can be changed.
2. Change from the programming level to the
working level: Any time and at any point you
may return to the working level by pressing
the turning-pushing knob for 1.5 seconds. The
changes to the stirring parameters entered
on the programming level will be stored imme-
diately upon leaving the programming level.
o P e r at I n g I n s t r u c t I o n s
menu
ProgrammIng
1. Turn the turning-pushing knob (B) to select
the program to be modified.
2. Press the turning-pushing knob (B) for 1.5
seconds. Set the stirring time to the desired
value (from 10 seconds to 5 minutes) by turning.
3. Confirm your input by briefly pressing the
turning-pushing knob (B). Brief pressing will
cause the program to go to the next stirring
parameter.
4. The next parameter is mixing speed. Select the
desired speed by turning the turning-pushing
knob and confirm by pressing briefly.
5. As the next parameter, pre-mixing may be
switched off or on, entering the pre-mixing
time (5 - 20 sec). Again, select be turning the
gB
13