LUND 86521213 Instructions De Montage page 3

8. With assistance, line up the mounting tabs on the Bull Bar with the outside of the (2) previously installed
Frame Mounting Brackets. Bolt the Bull Bar to the Frame Mounting Brackets with the included (4)
10mm x 30mm Hex Bolts, (8) 10mm x 30mm STD Flat Washers and (4) 10mm Nuts and (4) Lock
Washers (Figure 12). Snug but do not tighten hardware at this time.
9. Level and adjust the Bull Bar properly and tighten all hardware including factory hardware attaching the
air dam to the vehicle. Reinstall the tow hook if removed.
10. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
(Fig 1) Remove air dam from bottom of bumper
Front
Fig 3 Passenger/right frame Bracket
Passenger Side Installation Pictured
Remove (2) factory hex
nuts on outside of frame
Passenger Side Installation Pictured
Page 3 of 6
I-Sheet Number I-20253 Rev.A
Front
Fig 2
Front
Fig 4
REVOLUTION BULL BAR
2016 TOYOTA TACOMA
Spacer Washer will
cover this opening in
the end of the frame
Factory hex nuts
01/19/17