Tennant NOBLES V-WD-16B Opérateur Manuel page 7

3. Remove two unused squeegee mounting screws
from bottom of machine.
4. Install squeegee mounting bracket as shown.
Secure with screw and washers that you removed
(Figure 3).
5. Fasten squeegee bracket to mounting bracket. Use
two (2) clevis and cotter pins provided
(Figure 4).
6. Stand machine upright.
7. Insert spacer through hole in pedal then position
pedal between two holes in squeegee bracket.
Secure with hardware provided (Figure 5).
V- WD- 16B / V- WD- 61B (04- 10)
FIG. 3
FIG. 4
FIG. 5
8. Slide pedal between the two mounting arms on
back of machine. Align and insert clevis pin through
arms and slot in pedal, secure with cotter pin
(Figure 6).
9. Attach squeegee assembly to bracket as shown
and secure with two thumb screws (Figure 7).
10. Connect the 145 cm (57 in) vacuum hose to the
squeegee assembly and to cover snout
hose as shown using the hose clip provided (Figure
8).
OPERATION
FIG. 6
FIG. 7
Loop the
.
FIG. 8
EN
7