Degometal GO 252 Consignes De Sécurité Et Mode D'emploi page 19

Riveting
Insert the rivet into the nose piece (A) and the other end of the rivet into the work -
pieces to be riveted. Press the power switch until the rivet is removed, then release the
power switch. Tilt the riveting device backwards so that the removed rivet pin falls into
the mandrel collection device (C). If the rivet doesn't come off in a single working
stroke, repeat the procedure.
Failure
If rivets which exceed the indicated power of the device are used or if the battery is
empty or overloaded,the device will stop operating and the red LED
(H) will light up. Wait until the red LED (H) goes out and press the power switch (D) for
a short time. The device will revert to the original position.
If the battery is empty, the device is powered down by a protective circuit and the
working tool doesn't move any more.Don't press the power switch again after the
riveting machine has been powered down automatically, this may lead to battery
damage.
Notices on optimal handling of the battery
Keep the battery away from wetness and water. Only store the battery at temperatures
from 0° to 45°C. Do not leave the battery in the car, e.g. in summer. If the battery is
working for significantly shorter periods of time after a recharge, it is used up and needs
to be replaced. Please consider the notices for disposal.
www.degometal.com
19