Preparation; Changing Nose Assemblies - Degometal GO 252 Consignes De Sécurité Et Mode D'emploi

3. PREPARATION

Depicted components
The numbering of the components in the picture refers to the main exterior parts of the
battery riveting machine.
A) Nosepiece
B) Nose casing
C) Mandrel collector
D) Trigger
E) Riveting area illumination
F) Battery
G) Battery locking switch
H) Suspension hook
Charging the battery
Note: The battery is partially charged on delivery.
To guarantee full power of the battery, charge it completely in the charger before first
use. Pay attention to the charge indicator on the charging device. The Li-Ion battery
can be recharged at any time without affecting its fatigue life. Interrupting the charging
process doesn't damage the battery.
The battery is equipped with a temperature monitoring system which only allows for
charging between 0°C and 45°C.
Please consider the notices for disposal.
Removing the battery
The battery (F) is equipped with a locking mechanism (G) As long as the battery
remains inside the machine it is held in position by a spring. To remove the battery (F),
press the unlocking button (G) and pull the battery from the riveting device. Don't use
force.
Putting the device into operation
Insert the battery. Only use original Li-Ion batteries with the voltage depicted on the
type label of your battery riveting machine.
The use of other batteries may lead to injuries and risk of fire.
Push the battery (F) from under into the stand of the riveting machine, holding the
locking button (G) pressed. Push the battery into the stand completely until it is
securely locked.

4. CHANGING NOSE ASSEMBLIES

Changing nose pieces
The nose piece (A) are marked with numbers corresponding to the rivet cross - section.
Hold the power switch (D) pressed, that will lead to the clamping mechanism moving
into the rear position. Use the included wrench to switch to the required nose piece
and release the power switch.
www.degometal.com
18