Troubleshooting Table; Possible Causes - babymoov Yoo-Feel Notice D'utilisation

Problem
No sound and no image on
the receiver.
Continuous transmission.
Out-of-range alarm
permanently activated.
The image on the screen is
breaking up.
The 'signal loss' image is
displayed.
The image on the screen
freezes or appears in black
and white.
Range too small.
• Frequency: 2406 MHz ~ 2475 MHz
• Maximum output power. Camera: 19.09 dBm (e.i.r.p.)
• Nominal input values: 100 – 240 V AC, 50/60 Hz, 0.2 A
• Nominal output values: 5.0 V DC - 1000 mA
18

TROUBLESHOOTING TABLE

Possible causes

• The microphone's sensitivity is too low.
• The power adapter is not properly connected to
the transmitter.
• VOX mode active.
• Battery empty.
• The VOX mode sensitivity is too high.
• The distance between the camera and the
receiver exceeds the range.
• The range limits have been reached.
• The transmitter or camera is placed next to other
electrical appliances.
• The light intensity in baby's bedroom is too low,
night vision mode is activated.
• Walls/partition walls too thick between the camera
and receiver.
Receiver: 17.89 dBm (e.i.r.p.)
Yoo-Feel BABY MONITOR • Instructions for use
Solutions
• Increase the receiver volume.
• Check the connection.
• Press a button to activate the screen.
• Charge your receiver.
• Reduce the sensitivity of the VOX mode (see section
'RECEIVER OPERATION').
• Move the receiver and camera closer together.
• Bring the receiver closer to the camera.
• Move away any nearby electrical appliances or move the
camera away from any source of interference.
• Increase the brightness level in baby's bedroom if you
want to switch back to daytime mode.
• Move the camera and receiver.
Manufacturer: E-TEK Electronics Manufactory Ltd.
Model: ZD5C050100EUDW
Device version: V02