Controller Functions - Carrera RC Power Wave Instructions De Montage Et D'utilisation

Controller functions

1
ON
OFF
2
3
4
Troubleshooting
Problem Cause
Boat does not move
Either the switch on the controller or the boat is set to OFF.
There is no rechargeable battery in the boat or the battery is too weak.
The overheat protection has caused the boat's motor to cut out due to excess
temperature.
The battery or rechargeable battery in the transmitter or boat is too weak.
Boat cannot be
Boat starts moving unintentionally.
controlled
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
When the controller is switched on,
the red LED lamps at the front of the
controller are lit.
Steering digital proportional
Gas pedal to the rear: forwards
Gas pedal to the front: braking,
or backwards
The 2.4 GHz controller is suitable for
left- or right-handers and can be
adjusted as necessary by unscrewing
and refixing the steering unit accord-
ingly.
Function can be changed by
remounting the steering unit
To remount, unsrew the three screws on
the inside of the steering unit and screw
them to the opposite side.
Remove the cover plate from the other
side and mount the steering wheel to
the opposite side. Insert and tighten the
three inner screws again. Finished!
5
6
7
Solution
Switch on.
Insert charged battery.
Switch off the receiver.
Leave the RC boat to cool down for approx. 30 minutes.
Insert new battery or recharged battery.
First turn on the transmitter, only then the boat.
11
TH­TRIMM
Fine speed regulation
Here you can adjust the braking effect
on your boat.
TRIMM­steering
Fine steering adjustment
If the boat does not run in a straight
line, you can make fine steering adjust-
ments here.
Range control
On leaving the radio frequency, the boat
automatically returns to within range
radius.