Charging The Rechargeable Battery - Carrera RC Power Wave Instructions De Montage Et D'utilisation

Charging the rechargeable battery

1
2 2
RED = Charging GREEN = Ready
Installing the rechargeable battery
1
2
Fitting in the batteries
1
2
First connect the Carrera RC rechargeable
battery to the battery charger supplied. The
connection terminals between the battery
and the charger are designed to prevent
connection with the wrong polarity. Connect
the charger to a power source.
When the battery is properly connected and
charging normally, the red LED is constantly
lit. Once the battery is fully charged, the red
LED switches to green. The battery can now
be disconnected and installed in the Carrera
RC boat.
The boat is now ready for use.
Using a screwdriver, remove the cover of the
battery compartment in the Carrera RC boat.
Connect the end of the cable from the
Carrera RC boat with the charged battery.
Put the battery in place.
Replace the compartment cover using
a screwdriver.
Press the release button, then take the
battery compartment out of the controller.
Take care when inserting the batteries that
the polarity is correct. Push the battery
compartment back into the controller until
it clicks into place.
Now you can drive the boat
1
2
• Avoid constant motor operation.
• After use, remove or disconnect the battery.
• Clean the Carrera RC boat after use.
10
On first using it, the boat must be con-
nected with the controller.
To do this, you first switch on the con-
troller, plug in the battery to the boat,
switch the boat on and then press the
small button located in the battery com-
partment until the LED lamp lights up
continuously.
A connection can only be made when
the boat is in contact with the water.
Switch on the Carrera RC boat using
the ON/OFF switch.