Technical Data - Vetus Magnus Manuel D'utilisation Et D'installation

• Tighten screws evenly until sealant just starting to be squeezed
out from between the hatch and the deck.
• Clean of excess sealant and allow to set.
• Fully tighten all mounting screws once sealant has set.
5 Maintenance
Clean the anodized or powder-coated aluminium profiles regularly;
2 to 4 times a year, depending on how dirty they get.
Use only neutral cleaning agents. Do NOT use alkaline, acid and/or
abrasive cleaners.
After cleaning, apply a thin coat of transparent wax for protection.
Protect the sealing rubbers with talcum powder.
Magnus Hatches
Re-adjusting the hinges:
Adjust the hinges, with a 10 mm socket, if the hatch will not remain
in the open position, see Drawing 7.
1 Remove this screw in order to be able to fully open the
hatch during assembly.
2 Loosen the lock nut prior to opening or closing the
hatch.
The panel can open to 120 degrees (Altus) / 90 degrees
(FGH).
ALTUS + FGH
vetus® Hatches
2
1
6

Technical Data

Magnus:
Deck frame, hatch frame: Aluminium (6060) Window: PMMA 10 mm
Magnus hatches can be opened to a maximum of 200 degrees.
Altus:
Deck frame, hatch frame: Aluminium (6060) Window: PMMA 10 mm
Altus hatches can be opened to a maximum of 120 degrees
FGH:
Deck frame, hatch frame: Aluminium (6060) Window: PMMA 10 mm
FGH-hatches can be opened to a maximum of 90 degrees
This panel can open to 180 degrees.
MAGNUS
ENGLISH
5
7.0107