Transport And Storage; Installation; General Installation Advice - oventrop Unibox RTL Notice D'utilisation

Transport and storage

5. Transport and storage
Transport the product in its original packaging.
Store the product under the following condi-
tions:
Temperature -20°C to +60°C
range
Relative air Max. 95%
humidity
Particles Store dry and free from
dust
Mechanical Protected from mechani-
influences
cal agitation
Radiation Protected from UV rays
and direct sunlight
Chemical Do not store together
influences
with solvents, chemicals,
acids, fuels or similar
substances
6.

Installation

6.1 General installation advice

Note the following prior to installation:
• The lower edge of the Unibox RTL must be
at least 20 cm above the finished floor.
• The front face of the Unibox RTL must be
level with the finished wall.
Should the wall not have been
finished, take the plaster and tile
thickness into account.
• The opening of the wall box unit must face
downwards.
• The thermostat must not be influenced by
other heat sources.
• Use the enclosed brackets to align and fix
the Unibox RTL.
32
NOTICE
Risk of damage due to lubri­
cants
Seals may be destroyed by greasing
agents or oil.
f Do not use any greasing agents or
oil for the installation.
f Flush any dirt particles or grease or
oil residues out of the pipework.
f Consider the latest technical status
(e.g. VDI 2035), when choosing the
operating fluid.
1
2
3
4
5
6
7
Illust. 9: Installation cross section
(1) Block or stud wall
(2) Unibox RTL
(3) Plaster
(4) Pipe conduit unit (separate accessory)
(5)
Edge insulating strip (separate acces-
sory)
(6)
Screed
(7)
Protective tube (separate accessory)
Unibox RTL
102273580-V4.06.2020