Description Of Function - brennenstuhl Lufos 200 Mode D'emploi

Battery LED Light LUFOS 200

DESCRIPTION OF FUNCTION

With the "AUTO/OFF" switch, the light is switched completely off or active. (Fig. 8)
The light is equipped with a day/night sensor and an infrared sensor. The day/night sensor activa-
tes the light. The light switches on automatically when the infrared sensor detects movements in
the area.
If possible, do not point the motion detector toward swimming pools, heating air extractors,
air conditioners or objects subject to strong temperature variations. Avoid directing the motion
detector at trees or buses or places where pets frequently are. The motion director can be rotated
horizontally to the right and left, which changes the detection area.
When attaching the light, note that the motion detector reacts most sensitively to movements
that run across the detection field and least to movements directly toward the device.
ADJUST MOTION DETECTOR (PIR)
The switch-on duration can be set on the motion detector (Fig. 7). Turn the motion detector head
until the setting control is visible. With this control, you can select any switch-on time between
10 seconds and 30 seconds after the last movement has been detected. Turning the TIME control
in the clockwise direction increases the time period, and reduces it in the anti-clockwise direction.
REPLACE THE BATTERIES (Fig. 9 – 13)
Open the fastening screw (Fig. 9.1) by unscrewing it slightly. Press the release button (Fig. 9.2) and
pull the light from the mounting plate (Fig. 9.3). Pull the batteries out of the compartment using
the "removal tape" (Fig. 10). Install new batteries in the battery compartment. First put the "removal
tape" under the batteries. The correct polarity of the batteries is shown in the battery compartment
(Fig. 11). Press the release button (Fig. 12.1) and press the light onto the screwed-on mounting
plate (Fig. 12.2). Tighten the fastening screw (Fig. 12.3) again.
SERVICING
The light source of this light cannot be replaced. If the light source has reached the end of its
service life, the entire light must be replaced.
CLEANING
Do not use any solvents, corrosive detergents or the like. Use only a dry or slightly moist cloth
for cleaning.
10