Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Ceiling Cutout and Supporting Stud Housing
Dimensions
inches (mm)
1½'' x 3½'' x 27-13/16''
1½'' x 3½'' x 27-13/16''
1½'' x 3½'' x 27-13/16''
(38 x 89 x 707)
(38 x 89 x 707)
(38 x 89 x 707)
"
12
12
12
11/ 16
11/
11/
16
16
0-3''
0-3''
0-3''
(322)
(322)
(322)
(0-76)
(0-76)
(0-76)
1
1
21
21
21
/
/
4
4
"
"
(540)
(540)
(540)
16" (407)
16" (407)
16" (407)
SKU
VCIN36GWS
32-15/16'' (836)
VCIN42GWS
38-15/16'' (989)
VCIN48GWS
44-15/16'' (1,141)
VCIN54GWS
50-15/16''' (1,294)
VCIN60GWS
56-15/16'' (1,446)
Custom insert installation with hood
trims
⚠
CAUTION
The hood requires at least two people to lift it
safely.
Hidden surfaces may have sharp edges. Use
caution when handling the appliance. Failure
to do so may result in property damage or
personal injury.
1½'' x 3½'' x 23⅜''
1½'' x 3½'' x 23⅜''
1½'' x 3½'' x 23⅜''
(38 x 89 x 594)
(38 x 89 x 594)
(38 x 89 x 594)
⅝'' (16)
⅝'' (16)
⅝'' (16)
A
A
A
⚠
WARNING
To avoid electrical shock hazard, before installing, switch
power off at the service panel and lock the panel to
prevent the power from being switched on accidentally.
1. Turn power OFF at the service panel. Lock service
panel to prevent power from being turned ON.
2. Prepare the ductwork.
a)
Refer to "Ductwork preparation" on page 7 .
b) Install metal transition with backdraft damper so
that the flap opens up toward the ceiling. If
necessary, install thermal break and additional
backdraft damper (refer to "Attaching the hood
transition" on page 10).
3. Build the housing framework.
a)
Refer to "General information" on page 5 for the
model dimensions.
b)
Refer to "Clearances and requirements" on
page 6 for clearance specifications.
c) Build housing framework for applicable model
according to dimensions in "Preparing the ceiling
cutout and housing" beginning on page 10 .
4. Install the hood trim.
a) Hold trim flush to the bottom of the housing.
Secure the trim to the hood with (20) x 3/8''
(9.5 mm) screws.
b) The back trim piece may not be necessary in some
installation scenarios where there is a ½''
(12.7 mm) or less space between the hood and
the back wall.
5. Prepare for the wire routing.
a) Remove the junction box cover.
11
Publicité
Table des Matières
