Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
b) Remove one circular knockout.
B
c) Install strain relief (not included) into one of the
circular knockouts.
6. Install the unit.
a) Install the custom insert inside the custom
housing.
b) Secure to the rear of the housing framework using
six (6) x 1'' (25.4 mm) mounting screws, as
indicated below.
12
A
7. Connect to the ductwork.
8. Install the blower motor.
9. Connect the electrical wiring.
10. Install hood filters and grease trays.
11. Test the installation.
Blower motor installation
⚠
To reduce the risk of fire and electric shock, install this
range hood only with the blowers listed in the Ventilation
Planning Guide.
NOTE: Cutting the plug of the blower will void the
warranty or eligibility for return or exchange.
Installing the integral blower
Integral blower models are integrated into the hood at the
time of installation. Integral blowers should be installed
after the hood is mounted to the wall. For complete
installation instructions, see the instructions supplied with
the blower unit.
NOTE: Blower and hood image views will vary depending
on model.
c) Secure to the top of the housing framework using
eight (8) x 1'' (25.4 mm) mounting screws, 4 per
side.
a) Refer to "Choosing the correct blower" on page
10.
b) Refer to "Blower motor installation" on page 12 .
a) Connect wiring for applicable blower motor (see
blower instructions beginning on page 12 ).
a)
"Installing grease trays and filters" on page 16 .
a) Test the operation of the blower and the lights.
b) Be sure to check for back-draft. With the blower
on high, close the windows and doors to the area
to ensure that fan does not cause back drafting in
any outlet vent for another appliance.
CAUTION
Publicité
Table des Matières
