Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set. The ActionFreeze or Ac-
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
The door is not closed
correctly.
The ActionFreeze function
is switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
tionCool function is
switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been
opened often.
The ActionFreeze function
is switched on.
There is no cold air circu-
lation in the appliance.
7.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
Solution
Refer to "Closing the door".
Refer to "ActionFreeze func-
tion".
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off ActionFreeze or
ActionCool manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "ActionFreeze
or ActionCool function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Open the door only if neces-
sary.
Refer to "ActionFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
"Installation".
ENGLISH
11